top of page

Flame monitor sensor-- holder included.


Note: the flame monitor detects if the unit is working -  if there is a flame. If the flame monitor does not detect a flame after 25 seconds of operation start-up or dirt/dust is blocking the lens from detecting a flame, the system will immediately shut down. The flame monitor may require regular maintenance - typically routine cleaning of the flame monitor lens with a soft dry cloth or cotton tipped applicator in certain environments. If replacement of the flame monitor is required the monitor housing is held in position by two screws, and the monitor is plugged into the circuit board. Also note there have been reports of units not operating if the unit is facing directly into the sun, as the flame monitor may register this as an irregular flame.


Compatible with the following VAL6 models:

  • KBE1JA
  • KBE5L (single-speed and 2-step)
  • KBE5S
  • KBE5S-V

Until 2016 lot Z-01


  • Daystar until 2015 lot A-02


*Same as SKU: 1JA-B-48, DS-B-16


Manufacturer number: 50262 102008


    bottom of page